Guardian-technologies ACT1000 Manuel d'utilisateur télécharger pdf (Page 22)

ACT1000/2000 Operating Instructions Software Version 3.23-00

Page 19 of 32

Site Code 1

This function allows the 8-digit site primary code for the system to be entered. The controller

will recognize only cards with a matching site code. This code should also be quoted

whenever additional cards or tags are being ordered for this installation. The factory default

site-code is 10-2770-09, which allows the use of the test card supplied with the controller.

Site Code 2

This function allows an 8-digit site secondary code for the system to be entered. In addition

to the cards containing the primary site code, the controller will also recognize cards with this

site code. In this case, an offset may also be specified – this is a value that is added to the

card number of cards bearing the secondary site code, to prevent conflicts. If the secondary

site code is not being used, it should be set to 00-0000-00.

Card Format

• When “Active” is set to YES, the controller will recognize cards with a non-standard

(custom) format. The card information must be encoded using ISO/ABA Track 2 format

and may contain from 2 to 37 digits.

• When “Check All” is set to YES, the controller will also allow cards encoded with one

of its standard built-in formats. This could be used (for example) in a transitional period

while older legacy cards are being phased out.

• The Length field contains the total number of digits on the custom card. If this value is

non-zero, then any card with a different number of digits will be rejected.

• The Site field allows the entry of the location of the starting digit of the site code field on

the card. The length specifies how many digits are in the site code (1-5).

• The Card field allows the entry of the location of the starting digit of the card number

field on the card. The length specifies how many digits are in the card number (1-5).

• The Issue field allows the entry of the location of the starting digit of the issue number

field on the card. The length specifies how many digits are in the issue number (1-3). If

issue numbering is not being used, then the start digit and length should be set to zero.

Change PIN

The Change PIN function allows a different PIN to be configured for the installer. The user

will be prompted to enter a new six-digit code (it will not be displayed). The PIN must then

be re-entered for verification. The PIN will be accepted as long as it does not conflict with

any existing code (or duress code).

Factory Default

This function overwrites the controller’s non-volatile memory with the factory default

settings. All user names, timezones, card enables, log information etc. are completely deleted

so this function should be used with care.

It is always a good idea to factory default a new controller prior to initial configuration, or

if the controller software has been changed or upgraded.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 34 35

Pas de commentaire

Guardian-technologies ACT1000 Manuel d'utilisateur Page 22